S T 3 4 5 5 5 W SEAGATE Native| Translation ------+-----+-----+----- Form 3.5"/HH Cylinders 6311| | | Capacity form/unform 4550/ 6500 MB Heads 8| | | Seek time / track 10.5/ 1.3 ms Sector/track | | | Controller SCSI3 SI/WI/FA Precompensation Cache/Buffer 512 KB Landing Zone Data transfer rate 11.000 MB/S int Bytes/Sector 512 40.000 MB/S ext SYNC Recording method PRML 0/4/4,ZBR operating | non-operating -------------+-------------- Supply voltage - Temperature *C | Power: sleep W Humidity % | standby W Altitude km | idle W Shock g 10 | 75 seek W Rotation RPM 7200 read/write W Acoustic dBA spin-up W ECC Bit MTBF h 800000 Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** J U M P E R S ********************************************************************** SEAGATE ST34555W JUMPER SETTING REAR VIEW (TOP) J1 Auxiliary +-------------------+ +-- -1++---------+ -+ |||||||||||||||||1+-|::::::|| X X X X +- +-------------+-----+ +++++++++-5-G-G-12+ 68 pin I/O Cable+ |||||| Connection Male |||||| |||||| SCSI ID = 0 (none) Auxiliary option header |||||+-- SCSI ID = 1 ||||+--- SCSI ID = 2 pin-11 +5v ---------+||+---- SCSI ID = 4 pin-10 GND ----------++---+- SCSI ID = 8 +-- or pin-8 Activity LED Side View FRONT TOP (HDA) J2 87654321 +-- OF ---------------------------------P-W-A------+J1 DRIVE BOTTOM :::::::: +-- |||||||| Enable T-Res (W model only) +||||||+ Terminator Power| Start Delay (12 secs * ID) -+||||+- Terminator Power++ Motor Start --+||+-- Reserved | Write Protect ---++--- Parity Disable | | +--------------------------------+ | | Termination Power-source Table +------------------+ +--------------------------------+-------------+ | -----....-----....-----PWA edge-----| | 2 1 2 1 2 1 | | o X X o o o | | o X X o xxx | | A B C | +----------------------------------------------+ A = Drive Supplies Bus B = Drive Supplies Own C = Bus Supplies Drive A + B is valid! FRONT VIEW +--+RESERVED! Shipped with cover | | installed. | +Do not remove. Do not install jumpers TOP (HDA) ++---+ 1 -P-W-A---------------------+::::|::::::+-- * BOTTOM +----+123456 | J6 |||||| LED -+ |||||| Remote LED +||||+ ID 1 (pin-11 +5v) |||+- ID 2 Reserved -+|+-- ID 4 +--- ID 8 Caution: Do not use J2 jumpers on J6. The internal contacts will be bent and cannot be reused on J2 without them falling off. SCSI ID ------- +----------+-------------------------------+ | SCSI ID | Jumper Location | | | PINS | | | ID8 | ID4 | ID2 | ID1 | +----------+-------+-------+-------+-------+ | 0 | OPEN | OPEN | OPEN | OPEN | +----------+-------+-------+-------+-------+ | 1 | OPEN | OPEN | OPEN | CLOSED| +----------+-------+-------+-------+-------+ | 2 | OPEN | OPEN | CLOSED| OPEN | +----------+-------+-------+-------+-------+ | 3 | OPEN | OPEN | CLOSED| CLOSED| +----------+-------+-------+-------+-------+ | 4 | OPEN | CLOSED| OPEN | OPEN | +----------+-------+-------+-------+-------+ | 5 | OPEN | CLOSED| OPEN | CLOSED| +----------+-------+-------+-------+-------+ | 6 | OPEN | CLOSED| CLOSED| OPEN | +----------+-------+-------+-------+-------+ | 7 | OPEN | CLOSED| CLOSED| CLOSED| +----------+-------+-------+-------+-------+ | 8 | CLOSED| OPEN | OPEN | OPEN | +----------+-------+-------+-------+-------+ | 9 | CLOSED| OPEN | OPEN | CLOSED| +----------+-------+-------+-------+-------+ | 10 | CLOSED| OPEN | CLOSED| OPEN | +----------+-------+-------+-------+-------+ | 11 | CLOSED| OPEN | CLOSED| CLOSED| +----------+-------+-------+-------+-------+ | 12 | CLOSED| CLOSED| OPEN | OPEN | +----------+-------+-------+-------+-------+ | 13 | CLOSED| CLOSED| OPEN | CLOSED| +----------+-------+-------+-------+-------+ | 14 | CLOSED| CLOSED| CLOSED| OPEN | +----------+-------+-------+-------+-------+ | 15 | CLOSED| CLOSED| CLOSED| CLOSED| +----------+-------+-------+-------+-------+